Multimedia Pedestal For The Wave Radio And Wave Radio/CD PDF

11d ago
3 Views
0 Downloads
1.29 MB
12 Pages
Transcription

Multimedia Pedestal for the Wave Radio and Wave Radio/CDOwner’s Guide

Safety InformationWARNING: To reduce the risk of fire or electric shock, do not expose the pedestal to rain ormoisture. The apparatus shall not be exposed to dripping or splashing, and objects filledwith liquids, such as vases, shall not be placed on the apparatus.WARNING: As with any electronic product, use care not to spill liquids into any part of theradio. Liquids can cause a failure and/or a fire hazard.C AU T I O NAVISRISK OF ELECTRICAL SHOCKDO NOT OPENRISQUE DE CHOC ÉLECTRIQUENE PAS OUVRIRCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).NO USER-SERVICABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED PERSONNEL.ATTENTION : POUR RÉDUIRE LE RISQUE DE DÉCHARGEÉLECTRIQUE, NE RETIREZ PAS LE COUVERCLE (OUL’ARRIÈRE). IL NE SE TROUVE ÀL’INTÉRIEURAUCUNEPIÈCE POUVANT ÊTRE RÉPARÉE PARL’USAGER.S’ADRESSER À UN RÉPARATEUR COMPÉTENT.These CAUTION marks are located on the bottom of your pedestal:The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to thepresence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude toconstitute a risk of electric shock.The exclamation point within an equilateral triangle, as marked on the system, is intended to alert the user tothe presence of important operating and maintenance instructions in this owner’s guide.CAUTION: To prevent electric shock, match wide blade of plug to wide slot, insert fully.ATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondantede la prise et pousser jusqu’au fond.WARNING: No naked flame sources, such as lighted candles, should be placed on the apparatus.Please read this owner’s guidePlease take the time to follow this owner’s guide carefully. It will help you set up and operate your pedestal properly, andenjoy all of its advanced features. Save your owner’s guide for future reference.Note: DO NOT place the pedestal on any heat-sensitive surface, such as the finished surface of fine furniture. Like allelectrical equipment, it generates some heat. 1994-2003 Bose Corporation. No part of this work may be reproduced, modified, distributed or otherwise used without prior writtenpermission. All trademarks referenced herein are property of Bose Corporation. The Wave radio design is a registered trademark.2

Important Safety Instructions1.Read these instructions – for all components beforeusing this product.2.3.Keep these instructions – for future reference.Heed all warnings – on the product and in the owner’sguide.4.Follow all instructions.5.Do not use this apparatus near water ormoisture – Do not use this product near a bathtub,6.7.8.9.14. Refer all servicing to qualified service personnel.Servicing is required when the apparatus hasbeen damaged in any way: such as power-supplycord or plug is damaged; liquid has been spilled orobjects have fallen into the apparatus; the apparatus has been exposed to rain or moisture, doesnot operate normally, or has been dropped – Do notattempt to service this product yourself. Opening or removing covers may expose you to dangerous voltagesor other hazards. Please call Bose to be referred to anauthorized service center near you.washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, or anywhere else that water or moisture are present.15. To prevent risk of fire or electric shock, avoidoverloading wall outlets, extension cords, or integral convenience receptacles.Clean only with a dry cloth – and as directed byBose Corporation. Unplug this product from the walloutlet before cleaning.16. Do not let objects or liquids enter the product – asDo not block any ventilation openings. Install inaccordance with the manufacturer’sinstructions – To ensure reliable operation of the17. See product enclosure bottom for safety relatedmarkings.product and to protect it from overheating, put theproduct in a position and location that will not interferewith its proper ventilation. For example, do not placethe product on a bed, sofa, or similar surface that mayblock the ventilation openings. Do not put it in a built-insystem, such as a bookcase or a cabinet that may keepair from flowing through its ventilation openings.18. Use proper power sources – Plug the product into aDo not install near any heat sources, such as radiators, heat registers, stoves or other apparatus(including amplifiers) that produce heat.Do not defeat the safety purpose of the polarizedor grounding-type plug. A polarized plug has twoblades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wider blade or third prong areprovided for your safety. If the provided plug doesnot fit in your outlet, consult an electrician for replacement of the obsolete outlet.10. Protect the power cord from being walked on orpinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.11. Only use attachments/accessories specified bythe manufacturer.12. Use only with the cart, stand, tripod, bracket or table specifiedby the manufacturer or sold withthe apparatus. When a cart isused, use caution when movingthe cart/apparatus combinationto avoid injury from tip-over.13. Unplug this apparatus during lightning storms orwhen unused for long periods of time – to preventdamage to this product.they may touch dangerous voltage points or short-outparts that could result in a fire or electric shock.proper power source, as described in the operating instructions or as marked on the product.Information about productsthat generate electrical noiseIf applicable, this equipment has been tested and found tocomply with the limits for a Class B digital device, pursuantto Part 15 of the FCC rules. These limits are designed toprovide reasonable protection against harmful interferencein a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, this is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, you areencouraged to try to correct the interference by one ormore of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment andreceiver. Connect the equipment to an outlet on a different circuitthan the one to which the receiver is connected. Consult the dealer or an experienced radio/TV technicianfor help.This product complies with the Canadian ICES-003 Class Bspecifications.3

Setting UpBefore you begin.Thank you for selecting this multimedia accessory pedestal from Bose . Designed as asimple and attractive solution, it allows you to connect and play a variety of auxiliary components using your Wave radio/CD or Wave radio.Benefits of the pedestal include: Wave radio sound from a wide range of auxiliary audio sources Compact design that fits the lines and the functions of your Wave radio/CD (Figure 1a) orWave radio (Figure 1b) Quality construction and performanceFigure 1Front and rear connectionpanel of the (a) Wave radio/CD pedestal and (b) Waveradio pedestal(b)(a)INPUTINPUTSimplifying connections to your Wave radioWhile the connectors are in slightly different locations on the back of the two different pedestals, both provide the same connection options. They include three RCA input jacks and threepower outlet plugs on the rear panel. There is also a slot through which the Wave radiopower cord passes to reach a wall outlet. The two additional power jacks on the pedestal arefor plugging in added components. Or you may choose to connect the Wave radio powerplug to one of those pedestal jacks, as shown in Figure 2 on page 5.When all the other connections are made, simply plug the pedestal power cord into an AC(mains) wall outlet in your room. That supplies you with power enough for the radio and theadded components.4

Setting UpConnect your Wave radio to its pedestalBefore you seat the radio in the pedestal:1.Make the RCA jack connections, as shown in Figure 2a for the Wave radio/CD, or 2b forthe Wave radio. Insert the white cable connector from the pedestal into the white AUX IN jack labeled Lon the back of the radio. Insert the red cable connector from the pedestal into the red AUX IN jack marked R onthe back of the radio.2.Push the radio power plug through the cut-out in the pedestal so it can reach a wall outletor one of the three AC outlets on the rear of the pedestal.3.Plug the radio into an outlet.(a)Figure 2 How the (a) Wave radio/CD or (b) Wave radio connects to its pedestalWave radio/CDpower plugWhite RCA connectorRed RCA connector (b)Cut-out forthe radio plugRed RCA connectorWhite RCA connectorINPUTWave radio/CDpower plugCut-out forthe radio plugSeat your radio in the pedestalNext, place the radio flat in the open platform of the pedestal (Figure 3). You can feel when itis properly seated.Figure 3How the Wave radio/CDradio slips into the pedestal(Wave radio not shown)WARNING: Do not plug in the pedestal power plug until all other connections are completed.5

Setting UpAdding components to your pedestalNow you are ready to add multi-media sound sources (Figure 4).Figure 4(a) Wave radio/CD (a) andWave radio (b) seatedin and connected to itsappropriate pedestal(b) ckCloSetAlarmeModrmAla SetTunin3g2Pres16ets54elumVoXAUINPUT jacksfor component connectionsff/OOn/FMAMoze/SnoepSleveWadioRaINPUT jacksfor component connectionsRAUX INLINPUTThe added components might include a Bose Lifestyle system, your TV, VCR, multi-discchanger, or portable digital audio file player. In addition to the pedestal, you need an RCAcable to connect from each component to one of the three pairs of RCA inputs on thepedestal.Note: If your component does not include an RCA output cable, you may need to purchasean adaptor. Call Bose Product and Technical Services,1-800-367-4008, for details.6

Setting UpOne at a timeFor each separate component you add, there is a simple two-step process:1.Connect the ends of one RCA cable: to the audio output of the component you will use with the radio, and to one of the three pairs of INPUT jacks on the pedestal (Figure 5).When inserting the connectors, be sure to connect red-to-red and white-to-whiteat each end. This ensures consistent right and left channel connections for properperformance.Figure 5RCA cable from one component plugging into INPUTjacks on the pedestal forthe (a) Wave radio/CD and(b) Wave radio(a)Red RCAconnectorComponentRCA cable White RCAconnector(b) Red RCAconnectorRAUX INLINPUTComponentRCA cableWhite RCAconnector7

Setting Up2.Figure 6Insert the power plug of the component into one of the power outlets on the rear of thepedestal (Figure 6).(a)Plugging the componentpower cord into the (a)Wave radio/CD pedestaland (b) Wave radio pedestal power outlet Componentpower cordComponentRCA cableComponentpower cord (b)ComponentRCA cableRAUX INLINPUTRepeat steps 1 and 2 for any other components you want to connect.You can now plug the pedestal power cord into an AC (mains) wall outlet.8

Getting The SoundUsing your pedestal with components connectedWith auxiliary sound sources connected to your pedestal, you can easily command Wave radio sound from them.Before you begin to enjoy the sound, however, take note of which component is connected toINPUT 1, 2, or 3 on the back of the pedestal. Those numbers coincide with the AUX buttonson the pedestal front panel, which you will press to select the component you want to hear(Figure 7).Figure 7 AUX 1, AUX 2, and AUX 3buttons on the pedestal forthe Wave radio /CD(shown)X3AUX2AUX1AULEDsTo select and play a specific component1.Turn on your component using its remote or console Power button.2.Turn on the Wave radio/CD (or Wave radio) and select AUX (pressing the Wave radio/CD remote control AUX button will do both).3.Press the AUX 1, 2, or 3 button on the front of the pedestal.Note that the green LED (below the AUX button you press) lights up.To adjust the soundUse the Wave radio/CD (or Wave radio) remote to increase or decrease the volume of thecomponent that is playing.Use the component remote control or console buttons to adjust any other feature of thatsound source and to turn the component off, as well as on.TroubleshootingProblemWhat to doNo sound orsound is muffled A connected source isplaying, but no LED is lit Make sure that both the pedestal and the radio are plugged into a functioningpower outlet.Check the connection of the component to the pedestal. Make sure it is connected to oneof the three pairs of INPUT jacks on the back of the pedestal.Make sure the pedestal RCA connectors are inserted into the AUX IN jacks, red-to-redand white-to-white, on the Wave /CD radio/CD (or Wave radio). Refer to "Connect yourWave radio to its pedestal" on page 5.Make sure that both the pedestal and the radio are plugged into a functioningpower outlet.9

Technical InformationCustomer ServiceFor additional help in solving problems, contact Bose customer service. Refer to the addresslist on the inside back cover of this guide.WarrantyWhat is covered:All parts defective in material or workmanship.For how long:One year from the purchase date.What we will do:We will, at our sole option, repair or replace any defective parts free of charge.What you must do:A. Call Bose Customer Service and ask for shipping instructions.B. Properly pack the unit, if possible, in the original carton for shipping.Other conditions:This warranty is fully transferable for the one-year period following purchase.THE PROVISIONS OF THIS WARRANTY ARE IN LIEU OF ANY OTHER WARRANTY,WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, INCLUDING ANY WARRANTY OFMERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. BOSE CORPORATION’SMAXIMUM LIABILITY SHALL NOT EXCEED THE ACTUAL PURCHASE PRICE PAID BY YOUFOR THE PRODUCT. IN NO EVENT SHALL BOSE BE LIABLE FOR SPECIAL, INCIDENTAL,CONSEQUENTIAL, OR INDIRECT DAMAGES.This warranty does not cover a defect that has resulted from improper or unreasonable use ormaintenance, accident, improper packing, or unauthorized tampering, alteration, or modification as determined solely by us. This warranty is void if the label bearing the serial numberhas been removed or defaced.Other Law Rights:This warranty gives you specific legal rights, and you may also have other rights which varyfrom state to state or country to country. Some places do not allow limitations on implied warranties or the exclusion or limitation of incidental or consequential damages, so the abovelimitations or exclusions may not apply to you.Technical InformationPedestal power rating

Thank you for selecting this multimedia accessory pedestal from Bose ®. Designed as a simple and attractive solution, it allows you to connect and play a variety of auxiliary compo-nents using your Wave ® radio/CD or Wave ® radio. Benefits of the pedestal include: •Wave ® radio sound from a wide range of auxiliary audio sources